Waterproof Digital Thermal Probe temperature Sensor DS18B20 cable Length 1M

1.Brand New High Quality
2.The probe the temperature sensor DS18B20 original chip
3.High quality stainless steel tube encapsulation waterproof moistureproof prevent rust
4.Stainless steel shell 6*50mm
5.Power supply range: 3.0V to 5.5V 
6.Operating temperature range: -55°C to +125°C (-67°F to +257°F) 
7.Storage temperature range: -55°C to +125°C (-67°F to +257°F) 
8.Accuracy over the range of -10°C to +85°C: ±0.5°C. 
9.No other components, unique single bus interface
10.Output lead: red (VCC), yellow(DATA) , black(GND) 
11.Cable length: 100 cm

Harga Rp. 50.000,-

NodeMcu Lua WIFI Internet of Things development board based ESP8266 module

- Based ESP8266 Serial WiFi SoC dengan onboard USB to TTL menggunakan IC CP2102 (USB to UART Bridge Virtual COM Port)
- Bisa diprogram langsung lewat micro USB to USB.
- Development Board dengan Open-Source Firmware ini dapat dipergunakan untuk mendevelop aplikasi IoT hanya dengan beberapa baris Lua script.
- Wireless standard : IEEE 802.11b/g/n
- 6 x Digital I/O, 3 x PWM Channels, 1 x ADC Channel
- Full I/O control through WiFi network
- GPIO with 15mA current drive capability
- Supports Smart Link intelligent networking
- Built in 32-bit MCU
- built-in TCP/IP protocol stack, and support multiple TCP Client connection
- UART/GPIO data communication interface
Link referensi :
- driver cp2102, http://wwwsilabscom/products/mcu/Pages/USBtoU...
- Contoh program, http://nodemcucom
- Repository (NodeMCU GitHub), https://githubcom/nodemcu
http://esp8266ru/esplorer/

Contoh:
http://pinhoicodeboxnet/2015/06/building-weat...
http://wwwcnx-softwarecom/2015/10/29/getting-...
http://wwwinstructablescom/id/Programming-ESP...

This board uses a Silicon Labs CP2102 USB to serial converter IC. You can download the USB drivers from here:
https://wwwsilabscom/products/mcu/Pages/USBto...

Harga Rp. 115.000,-

Arduino Mega REV3 ATmega2560-16AU Board + USB Cable

Arduino Mega REV3 ATmega2560-16AU Board + USB Cable

Microcontroller	ATmega2560
	Operating Voltage	5V
	Input Voltage (recommended)	7-12V
	Input Voltage (limits)	6-20V
	Digital I/O Pins	54 (of which 14 provide PWM output)
	Analog Input Pins	16
	DC Current per I/O Pin	40 mA
	DC Current for 3.3V Pin	50 mA
	Flash Memory	256 KB of which 4 KB used by bootloader
	SRAM	8 KB
	EEPROM	4 KB

Harga Rp. 160.000.-