New KK2.1.5 LCD Flight Control Board 6050MPU 644PA Multirotor update version for KK2 kk2.1
The KK2.1.5 is next big evolution of the first generation KK flight
control boards. The KK2.1.5 was engineered from the ground up to bring
multi-rotor flight to everyone, not just the experts. The LCD screen and
built in software makes install and setup easier than ever. A host of
multi-rotor craft types are pre-installed, simply select your craft
type, check motor layout/propeller direction, calibrate your ESCs and
radio and you’re ready to go! All of which is done with easy to follow
on screen prompts!
The original KK gyro system has been updated to an incredibly
sensitive 6050 MPU system making this the most stable KK board ever and
allowing for the addition of an auto-level function. At the heart of the
KK2.1.5 is an Atmel Mega644PA 8-bit AVR RISC-based microcontroller with
64k of memory. An additional polarity protected header has been added
for voltage detection, so no need for on-board soldering. A handy piezo
buzzer is also included for audio warning when activating and
deactivating the board.
The KK2.1.5 added polarity protection to the voltage sense header and a
fuse protected buzzer outputs, in case something is accidentally
plugged in incorrectly. The voltage sense line has been updated for
better accuracy. The board is clearly labeled and the voltage sense line
color has been changed to red for easy identification, making
installation and connections a snap.
If you’re new to multi-rotor flight or have been unsure about how to
setup a KK board then the KK2.1.5 was built for you. The 6 Pin USBasp
AVR programming interface ensures future software updates will be quick
and easy.
Specs:
Size: 50.5mm x 50.5mm x 12mm
Weight: 21 gram (Inc Piezo buzzer)
IC: Atmega644 PA
Gyro/Acc: 6050MPU InvenSense Inc.
Auto-level: Yes
Input Voltage: 4.8-6.0V
AVR interface: standard 6 pin.
Signal from Receiver: 1520us (5 channels)
Signal to ESC: 1520us
Size: 50.5mm x 50.5mm x 12mm
Weight: 21 gram (Inc Piezo buzzer)
IC: Atmega644 PA
Gyro/Acc: 6050MPU InvenSense Inc.
Auto-level: Yes
Input Voltage: 4.8-6.0V
AVR interface: standard 6 pin.
Signal from Receiver: 1520us (5 channels)
Signal to ESC: 1520us
Firmware Version: 1.9S:
Pre-installed firmware.
Dualcopter
Tricopter
Y6
Quadcopter +
Quadcopter X
Hexcopter +
Hexcopter X
Octocopter +
Octocopter X
X8 +
X8 X
H8
H6
V8
V6
Aero 1S Aileron
Aero 2S Aileron
Flying Wing
Singlecopter 2M 2S
Singlecopter 1M 4S
Pre-installed firmware.
Dualcopter
Tricopter
Y6
Quadcopter +
Quadcopter X
Hexcopter +
Hexcopter X
Octocopter +
Octocopter X
X8 +
X8 X
H8
H6
V8
V6
Aero 1S Aileron
Aero 2S Aileron
Flying Wing
Singlecopter 2M 2S
Singlecopter 1M 4S
Harga Rp. 400.000,-
No comments:
Post a Comment