jD-IOBoard v1.1, Driver board for your needs
jD-IOBoard just got better. This is our new v1.1 board. So take a look at our document site to notice differences with older board.
If you need to drive LED strips, LEDs, Lamps, Relays or similar devices jD-IOBoard is the answer for your needs. This board is fully Arduino compatible board and it has 6 high power outputs and can handle all the way 42 Volts and 500mA / output pin.
Board have easy access to FTDI / UART and I2C ports. Among high power outputs there are several TTL level GPIO pins and Analog pins.
Technical data:
Atmega 328P MCU
ULN2003A darlington array for high power outputs
6 x TTL GPIO pins
6 x TTL Analog pins (only 4 if using I2C bus)
FTDI connector
ISP pins for deep programming
Size: 37mm x 18mm
Documentation:
Assembly and usage documentation in jDoc - jD-IOBoard
Source codes etc in Google Arducodes repository
http://www.youtube.com/watch?feature=player_embedded&v=dKqLizMjmIs
http://www.youtube.com/watch?feature=player_embedded&v=Q2oT808mJnQ
Harga Rp. 400.000,-
No comments:
Post a Comment