OpenPilot CC3D 32Bits Flight Controller & Protect Case

OpenPilot CC3D 32Bits Flight Controller & Protect Case for Quadcopter QAV250 450

 

 

100% Brand New

 

The CC3D board is an all-in-one stabilization hardware which runs the OpenPilot  firmware. It can fly any airframe from fixed wing to an octocopter and is  configured and monitored using the OpenPilot Ground Control Station (GCS)  software.

 

CopterControl from the OpenPilot project  introduces a new generation of multi-purpose aircraft stabilization platforms.  The CC3D has been designed from the ground up to perform the following functions:

- a MultiRotor controller with auto-level, including TriCopters, QuadCopters and  HexaCopters

- a Flybarless Helicopter controller with auto-level

 

 

The CopterControl hardware has the following features:

Powerful STM32 32-bit microcontroller running at 90MIPs with 128KB Flash and  20KB RAM

3-axis high-performance MEMs gyros and 3-axis high-performance MEMs  accelerometer

Tiny 36mmx36mm 4 layer PCB for superior electrical noise reduction and flight  performance.

Software support for Windows, Mac and Linux

Direct high speed USB support with no drivers required, a truly plug and play  device.

Spektrum satellite receiver support

Futaba S-BUS hardware support

Innovative Flexi-port technology for superior port flexibility

4Mbits on-board EEPROM for configuration storage

 

Manual:

//wiki.openpilot.org/display/Doc/CopterControl+Hardware+Manual

 

Setup Wizard: 

//wiki.openpilot.org/pages/viewpage.action?pageId=20250682

 

Package includes:

1 x CC3D OpenPilot FC

2 x 4pin cable

1 x 8pin cable

1 x Protect case

'
Harga Rp. 325.000,-